PT Inotek Pratama · (021) 452-52-87 · admin@inotekpratama.com · WhatsApp (+62) 821-1396-3063
Dehumidifier Type
DES-80
PORTABLE DEHUMIDIFIER SERIES
The DES-80 is a small portable unit built around a zeolite rotor, at a low unit cost. It reaches the performance of an industrial desiccant dehumidifier in that smaller body. A small heater regenerates the desiccant rotor, which releases the moisture into a container, so no ducting work is needed. Performance stays constant when inlet temperature and RH vary.
The DES-80 stops on its own when the water container is full, and a red warning light comes on. Electrical efficiency is high. The unit does not freeze and runs easily close to 0 (ZERO) degrees Celsius.
The unit is very quiet (SILENT): only the fan moves. It has no compressor, so the service life is long, and it suits 24-hour operation.
Features
- Very Low Temperature
- Constant Capacity
- Automatic Control
- Silent Operation
- Light Weight
- Large Water Container
- Dial Humidity Control
- Drain Pipe Outlet
01 Specifications
Specifications for DES-80
- Type
- DES-80
- Power Supply
- 230V~50Hz
- Power Consumption
- 720 W
- Running Current
- 3.1 A
- Dimensions (W X H X D)
- 416 X 600 X 190 mm
- Net Weight
- 9 KG
- Operational Temp. Range
- 0ºC – 35ºC
- Noise Level
- 41 dB
02 Troubleshooting
Common problems and how to handle them
If your problem is not listed here, contact our after-sales team.
The unit does not function
- Check that the fuse in the plug is ok.
- Check the plug is inserted in mains and mains power is on.
- Is tank full light on? Check water tank and empty if necessary.
- Check if the float of the water tank is blocked by foreign material. Is the float of water tank correctly positioned?
- Is the unit standing upright and level?
Abnormal noises from the motor
- Check and clean the air filter
- Is the unit standing upright and on a level surface?
The unit leaks water
- Has the unit been tipped?
- Check if the float of the water tank is blocked by foreign material.
Changes in temperature at the air outlet
- Is the unit on “Standby” or “Normal” operation status?
- The internal heater of the appliance will be switched on/off automatically.
After the unit has been switched off, the fan motor is still running
- After the unit stops, about two minutes are needed to cool down the electric heater by running the internal fan.
The water tank was not properly inserted into the unit
- Make sure to insert the water tank in its right position.
- Is the float of the water tank correctly positioned?
Ask about DES-80 availability
Tell us the room size and its humidity conditions.